The U-shaped brush roller cleaning machine is a highly efficient and reliable cleaning device. As a precision equipment, some abnormal situations may occur during long-term use. The following introduces the solutions to common problems.
Please make sure to cut off the water and power supply before troubleshooting.
U-shaped Hair Roller Apple Cleaning Machine
Fault 1: The bristle roller does not rotate
Solution
1. Check if the drive belt is abnormal. If the belt is too loose, adjust the motor bolts to adjust the tightness. If the belt ages or breaks, it should be replaced immediately.
2. Check if the motor is abnormal. If the motor makes abnormal noises or has a burnt smell during operation, it indicates that the motor is burned out. Please have a professional electrician repair it or replace it with a new one.
3. Check if there are any foreign objects stuck between the gears. If there is any foreign object, manually rotate the bristle roller to find and remove it..
Fault 2: Poor cleaning effect.
Solution
1. Check if the brush is functioning properly. If the brush is worn out by more than one third, replace it with a new one.
2. Whether the spray water holes are normal. If the water spray holes are clogged, rinse them with a fine needle or a high-pressure water gun and install a filter at the water inlet.
3. Excessive cleaning. Add it evenly to the cleaning machine according to the approved cleaning volume of the equipment.
Fault 3: Abnormal sounds or vibrations of the equipment.
Solution
1. Check if the bearing is functioning properly. If there is a loud friction sound during operation, the bearing is damaged and needs to be replaced immediately.
2. Check whether the gears are normal and lubricated. If the gears mesh incorrectly, adjust the position of the gears. If the wear is severe, replace the gear with a new one.
3. Check whether the bristle roller is clean. If there are too many foreign objects entangled on the bristle roller, please clean them up in time. If the wool roller shaft is bent, adjust or replace it.
Fault 4: Leakage
Solution
1. Check if the sealing ring is functioning properly. If the leakage point is at both ends of the roller shaft, the sealing ring is aged or worn and needs to be replaced.
2. Check if the drain pipe is functioning properly. It is possible that the drainage is not smooth, causing the water level to be too high. Please clean the filter screen and pipes at the drain outlet in time.
3. Check whether the water pipe joints or screws are normal. Tighten all the water pipe joints.
The above operations can solve common fault problems. If more complex faults occur, please contact professionals in time and do not disassemble the machine by yourself.